Table of Contents
Advertisement
System Setup : Advanced menu
Submenu
Lamp Settings
HDMI Settings
Baud Rate
Test Pattern
Quick Cooling
Functions and Descriptions
•
Reset Lamp Timer
Activate this function only after a new lamp is installed. When you select Reset,
a "Reset Successfully" message is displayed to notify that the lamp time has
been reset to "0".
•
Lamp Timer
Select to learn the duration (in hours) of lamp usage which is automatically
calculated by the built-in timer.
Total (equivalent) lamp hour = 2.0 x (hours used in Normal mode) + 1.4 x
(hours used in Economic mode) + 1.0 x (hours used in SmartEco mode)
•
HDMI Range
Selects a suitable RGB color range to correct the color accuracy.
•
Auto: Automatically selects a suitable color range for the incoming
HDMI signal.
•
Full: Utilizes the Full range RGB 0-255.
•
Limited: Utilizes the Limited range RGB 16-235.
HDMI Range is only available when the HDMI signal is selected.
•
CEC
When you connect an HDMI CEC-compatible device to your projector with an
HDMI cable, turning on the HDMI CEC compatible device automatically turns
on the projector, while turning off the projector automatically turns off the
HDMI CEC compatible device. You can use the projector's remote control to
control your HDMI CEC-compatible devices. See item 17 on page
details.
•
Power On Link/Power Off Link
When you connect an HDMI CEC-compatible device to your projector with an
HDMI cable, you can set the behavior of powering on/off between the device
and the projector.
Turning on/off either the connected device or the
Bidirectional
projector can turn on/off both.
When the projector is turned on/off, the connected
From Projector
device will be activated/shut down, too.
When the connected device is turned on/off, the
From Device
projector will be activated/shut down, too.
Select a baud rate that is identical with your computer's so that you can connect
the projector with a suitable RS-232 cable and update or download the
projector's firmware. This function is intended for qualified service personnel.
Enable this function to display the grid test pattern, which helps you adjust the
image size and focus so as to check if the projected image is free of distortion.
On
Select
to shorten the projector cooling time from a normal 90-second
duration to approximately 15 seconds.
10
for
39
Menu Functions
Advertisement
Table of Contents
