Table of Contents
Advertisement
Settings
• Wall Color
• Projector
Position
• Test Pattern
• Auto Source
• Menu Type
• HDMI Range
• Reset Lamp
Timer
• Reset All
Settings
• Information
28
Menu Functions
Press OK to enter its submenu.
Press
BACK to save your changes and exit.
See below for more details.
Enable this function to help correct the projected picture's color when the projection
surface is not white. You may choose a color similar to that of the projection surface
from these options: Light Yellow, Pink, Light Green, or Blue.
The projector can be installed on a ceiling or behind a screen, or with one or more
mirrors. See
Choosing a location
Enable this function to display the grid test pattern, which helps you adjust the image
size and focus so as to check if the projected image is free of distortion.
Sets whether the projector searches automatically for input sources. Select On to
enable the projector to scan for input sources until it acquires a signal. If the function
is set to Off, the projector selects the last used input source.
Switches to the Advanced OSD menu.
Selects a suitable RGB color range to correct the color accuracy.
•
Auto: Automatically selects a suitable color range for the incoming HDMI
signal.
•
Full: Utilizes the Full range RGB 0-255.
•
Limited: Utilizes the Limited range RGB 16-235.
HDMI Range is only available when the HDMI signal is selected.
Activate this function only after a new lamp is installed. When you select Reset, a
"Reset Successfully" message is displayed to notify that the lamp time has been
reset to "0".
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, Language, Projector Position,
Reset Lamp Timer, and High Altitude Mode.
Displays the following information about your projector.
•
Source: Displays the current signal source.
•
Picture Mode: Displays the current Picture Mode.
•
Resolution: Displays the native resolution of the input source.
•
Color System: Displays input system format.
•
Lamp Usage Time: Displays the number of hours the lamp has been used.
•
3D Format: Displays the current 3D mode.
3D Format is only available when 3D Mode is enabled.
•
Firmware Version: Displays the firmware version of your projector.
Some information is given only when certain input sources are in use.
for details.
Advertisement
Table of Contents
