Units Of Measure - New Holland LW170 Service Manual

LW170-LW190

UNITS OF MEASURE

Units of measure used in this manual are those
adopted by the International System which replace
the units previously used by the M.K.S. system.
Force: decanewton (daN) replaces kilogram
(kg)
Pressure: bar, replaces kg/cm
Torque: decanewton x meter (daNm) replaces
kgm
The following tables is to be used to convert units of
measure:
multiply
Force kg
2
Pressure kg/cm
Torque kgm
Note - For current service use, the following
equivalences can be considered to be valid:
2
kg = daN; kg/cm = bar; kgm = daNm.
Carefully read personal and machine SAFETY PRECAUTIONS (at the beginning of this manual)
2
by
to obtain
0.9807 daN
0.9807 bar
0.9807 daNm
CLASSIFICATION OF STANDARD COMPO-
NENTS TO DETERMINE THE TIGHTENING
TORQUES
Note - In case, in the different sections, the tightening
torque is not listed, refer to the table "TIGHTE-
NING TORQUES", only after identifying exactly the
component.
The latter is identified by a coded eight digit number,
allowing a complete description of the item.
Example:
I / a b c d e / f
I - Standard index digit
It is always represented by the digit 1. This number
indicates that the item can be fabricated in a number
of versions differing for material and coating.
a - b - c - d - e - Standard base digits
It is a number always composed of five digits
identifying dimensional specifications of the item.
f - Material index digit
This digit indicates the material used for a defined
item. Its meaning is indicated in the table that follows.
g - Coating index digit
It indicates the coating applied to a defined item.
0 - 15
g