Fujitsu ETERNUS JX40 S2 Operating Manual page 62

Power Supply Unit
Ê At the rear of the storage subsystem, switch off the defective power supply
unit using its power switch.
Ê Remove the AC cord clamp and remove the lead.
Figure 31: Ejector levers of a power supply unit
Ê Release the latch of the ejector lever on both sides using both hands, and
pull the unit out halfway.
Ê Take the power supply unit out of the bay while supporting its bottom.
To install the power supply unit follow the above steps in reverse.
Ê Push the new power supply unit into the empty bay halfway while supporting
its bottom.
Ê Open the ejector levers and insert the power supply unit. Then press the
levers fully inward and confirm that the latches are fastened.
Ê Connect the lead to the power supply unit and set the AC cord clamp.
Ê Connect the power cable to the mains.
Ê Verify that the Power LED of the unit shows green light.
62 Operating Manual
Replacing Components
ETERNUS JX40 S2