Miter Gauge Adjustments - Grizzly G0771Z Manual

Miter Gauge
Adjustments
The miter gauge is equipped with stop screws that
allow you to easily adjust the miter gauge 0°– 30°
left, 90°, and 0°–45° right. The stop screws con-
tact the shaft, which moves in or out of the way
for adjustments.
Tools Needed
Phillips Head Screwdriver .................................. 1
90° Square ........................................................ 1
45° Square ........................................................ 1
30° Square ........................................................ 1
Wrench 8mm ..................................................... 1
Checking/Setting 90° Stops
DISCONNECT SAW FROM POWER!
1.
Slide miter gauge into T-slot on table.
2.
Place square evenly against face of miter
3.
gauge and blade, as shown in Figure 128.
Blade
Square
Miter Gauge
Figure 128. Checking 90° stop on miter gauge.
— If square touches miter body and body
of blade evenly at same time, then it is
square to blade. No adjustments are nec-
essary.
— If square does not touch miter body and
blade evenly, then proceed to Step 5.
Remove miter gauge from miter slot.
4.
Model G0771Z (Mfd. Since 01/21)
5. Loosen two Phillips head screws that secure
90° stop plate (see Figure 129).
Miter Gauge
Shaft
Qty
Stop Plate
Figure 129. Checking 45° stop on miter gauge.
Using a square, position miter shaft at 90° to
6.
miter gauge body.
Tighten stop plate screws.
7.
Checking/Setting 45° Stops
Follow the same process with the 45° and 30°
stops that you followed with the 90°, except using
a 45° square or adjustable square to verify that
the miter body is 45° to the blade.
Adjustment
Screws
-71-