Dust Collection - Grizzly G0771Z Manual

28. Install end cap on right end of front fence rail
in the same manner as you did on the left end
(Step 7 on Page 21).
29. Secure rear access panel with (6) Phillips
head screws.
30. Mount dust port with (4) Phillips head screws
(see Figure 31).
Figure 31. Dust port installed.
31. Install miter guage handle and 6 x 20mm
washer See Figure 32.
Figure 32. Miter guage handle and washer.
-24-

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
x 4
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust-collection "how-to" book.
To connect a dust-collection hose:
Fit 4" dust hose over dust port, as shown in
1.
Figure 33, and secure in place with a hose
clamp.
Tug hose to make sure it does not come off.
2.
Note: A tight fit is necessary for proper per-
formance.
Figure 33. Example of dust hose attached to
dust port.
Model G0771Z (Mfd. Since 01/21)