Table of Contents
Advertisement
This function, when enabled allows for three modes of Routing Information Protocol
LAN RIP —
to be used:
•
RIP 1 Compatible = This function allows your CyberSWITCH to listen to RIP type 1, and
RIP type 2 packets, but only broadcast RIP type 1 packets.
•
RIP 1 = This function allows your CyberSWITCH to listen to and broadcast RIP type 1
packets only.
•
RIP 2 = This function allows your CyberSWITCH to listen to and broadcast RIP type 2
packets only.
•
RIP off = Disables the CyberSWITCH's ability to detect and respond to any RIP packets.
IPX Routing —
Click this radio button to enable IPX Routing in your CyberSWITCH.
Select the Frame Type for IPX Routing. The options are; Ethernet II, Ethernet
Frame Type —
802.2, and Ethernet 802.3.
Remote Connections
The QuickSET Remote Connections Panel shown in Figure 12, below, is used to set up any remote
devices you wish your CyberSWITCH to connect to.
Remote Connections Panel —
scroll through a list of remotes. You can enable or disable any remote by clicking the Enable
Remote radio button on or off. You can disable Authentication by clicking the Disable
Authentication checkbox.
Figure 12 QuickSET Remote Connections Panel
You can use the scroll bar in the Remote Connections window to
Planning Your Router's Configuration
CyberSWITCH 100 Advanced User Information 31
Advertisement
Table of Contents
