Configuration Procedure - Viessmann Vitocal 300-G Pro SPS Installation And Service Instructions For Contractors

Commissioning, inspection, maintenance
Commissioning the system

Configuration procedure

For a graphic depiction see the following pages.
Symbols:
Day mode
Night mode
Time and date are shown at the top right
Switching the heat pump on and off
Â
Menu
å
Calculated set room temperature, in this example
24 °C
Flow temperature, in this example 38 °C
Average outside temperature, in this example
15 °C
Selection display
Æ
Messages:
Fault
Entering the configuration menu
Turn on the ON/OFF switch of the heat pump control unit.
■
After approximately 30 s the display is shown on the screen
■
■ Select
å
Default screen for Viessmann control
System ON
15.0 °C
Fig.28
48
(cont.)
Operating principles
Note
Symbol å on the default screen and almost every
other screen takes you straight to the main menu
screen.
Calling up the configuration screens
■ From the main menu select
■ The password must be entered following a system
start or prolonged break
Select "Configuration"
■
16:03:53
19/06/2013
24.0 °C
Flow temperature 38.0 °C
"Login"
å