Installing System Memory - EVGA Z590 DARK User Manual

EVGA Z590 DARK (122-RL-E599)

Installing System Memory

Your Z590 DARK has (2) 288-pin slots for
DDR4 memory. These slots support 4GB,
8GB, 16GB, and 32GB DDR4 Unbuffered
non-ECC DIMMs. There must be at least
one memory slot populated for the board to
boot and operate.
The Z590 DARK supports Dual-Channel
DDR4 memory, a maximum of 64GB and
up to 5333MHz+ (OC). It is recommended
to always use a 2 DIMM Dual Channel kit
for the Z590 DARK. Fill the memory
slots in the following order: 1, then 2.
See chart to the right:
Use the following procedure to install
memory DIMMs. Note that there is a
key notch near the center of the DIMM slots. This matches the gap on a DDR4
DIMM to ensure the memory is installed properly, and to prevent the
incorrect installation of memory.
1. Unlock a DIMM slot by pressing both module clips outward.
2. Align the memory module to the DIMM slot, insert the module
vertically into the slot, and press straight down to fully seat the module.
The plastic clips at top side of the DIMM slot should automatically
lock the DIMM into the connector.
Note: The memory controller on most Rocket Lake-S CPUs runs at a default
frequency of 3200MHz, while most Comet Lake-S CPUs run at a default
frequency of 2933MHz. Achieving memory speeds above the CPU's default
speed may require manual setting of the memory timings, frequency and
voltages and/or overclocking of the CPU.
Refer to the memory manufacturer specifications for the recommended
memory timings. For overclocking support you can visit our forums:
https://forums.evga.com/
- 30 -