Empire Comfort Systems DVLXB55BP90N-1 Installer's Manual page 58

Cleaning the Fuelbed and the Glass
Clean the glass periodically. We recommend gas fireplace glass
cleaner.
During start-up, condensation forms on the inside of the glass
causing lint, dust and other airborne particles to cling to the glass.
Also initial paint curing may deposit a film on the glass. Allow the
fireplace to cool and then clean the glass two or three times with
gas fireplace glass cleaner or a non-abrasive household cleaner and
warm water. After that, clean the glass two or three times during
each heating season or more often if necessary.
Clean glass with cleaner designed for fireplaces.
Do not use ammonia based or abrasive cleaners on glass. Do not
attempt to clean glass when glass is hot.
1. Avoid breaking the glass.
2. Do not operate this appliance without the glass or with
broken glass. Have a qualified service person replace
damaged glass and gasket using materials specified by
Empire Comfort Systems.
3. Do not abuse or strike the glass.
4. The use of substitute glass will void all product
warranties.
Do not operate the appliance with the glass removed,
cracked, or broken.
To remove the glass for cleaning, follow the instructions shown
here.
1. Use a screw driver to unlock barrier screen.
2. Loosen the two (2) locks in the top corners by folding tabs
towards top of barrier screen frame.
58
MAINTENANCE AND SERVICE
WARNING
WARNING
WARNING
3. Tilt the barrier screen out from the top and lift the
bottom out of the fireplace.
4. Remove the barrier screen from the fireplace and set to
the side. Be aware that if lint/dust is present on the mesh
it may stain carpet or furnishings.
5. Put the suction cups on the inner glass.
6. Loosen the four (4) 1/4 turn fasteners and remove the
glass retainer.
7. Tilt the glass towards yourself and lift it out. Be aware
that if any soot is present on the glass, it may stain carpet
or furnishings. Set the glass aside and use a fireplace glass
cleaner to clean the glass.