Table of Contents
Advertisement
8. Using the handle supplied with the oven, pull
out the air plate.
Figure 24
9. Remove the nozzles as follows:
a.) Remove the bolt from the hold down
bracket. Lift the bracket straight up and
slide out either end of the oven.
Figure 25
b.) Push the nozzles toward the back wall of
the oven. Lift the front end and turn it to-
ward you slipping the back end from the
duct.
10. Slide the return air diverters out of the oven.
Maintenance
11. Soak the conveyor in a hot water/detergent
mix.
12. Clean the crumb pans, return air diverters,
nozzles, air plates, and end plugs with a hot
water/detergent mix. Rinse with clean water.
For difficult cleaning use a heavy duty de-
greaser or oven cleaner that is safe for alumi-
num.
NOTE: DO NOT immerse the end plugs. They
contain insulation.
13. Clean the oven interior with an all purpose
cleaner or an oven cleaner that is safe for alu-
minum.
14. Move the oven to clean underneath. DO NOT
damage the gas hose or electrical cords when
moving.
Every 12 Months:
A factory authorized service person should:
1. Open and clean the inside of the control panel.
2. Check and tighten all electrical connections.
3. Check DC gear motor brushes for wear.
4. Check conveyor drive chain for cleanliness
and proper lubrication.
If maintenance is required contact your local ser-
vice company, a factory representative or the
Blodgett Oven company.
WARNING!!
Always disconnect the power supply be-
fore cleaning or servicing the oven.
17
Cleaning
Advertisement
Table of Contents
