Hard System Recovery - Panasonic KX-HDV800 Installation & Administration Manual

HARD SYSTEM RECOVERY

If you have forgotten the Admin PIN code, the only way to reset it to default is to
do a hard factory reset. This is the same as the Factory reset in the system menu
(
(MENU) > SYSTEM > FACTORY RESET).
This erases all settings including account information and contacts!
Disconnect the power supply cable. Note that this is the same as the network cable
if the phone uses Power over Ethernet.
Press and hold the
the KX-HDV800). Hold the button pressed until the SYSTEM RECOVERY menu is
shown on the display.
You can press any other button than 1, 2, or 3 to start the phone without resetting.
Press 1 to select
Upgrade to the latest version of the software when the phone has started and redo
the setup of account and other settings (see page 11).
This replaces the current software with the one supplied with the phone. All settings are
erased.
Disconnect the power supply cable. Note that this is the same as the network cable
if the phone uses Power over Ethernet.
Press and hold the
the KX-HDV800. Hold the button pressed until the SYSTEM RECOVERY menu is
shown on the display.
You can press any other button than 1, 2, or 3 to start the phone without restoring
Press 3 to select
written to the memory.
Upgrade to the latest version of the software when the phone has started and redo
the setup of account and other settings (see page 11).
(MENU) button while you connect the cable again (i.e. starts
(MENU) button while you connect the cable again (i.e. starts
37
OK.
OK.