Related Manuals for Panasonic KX-HDV230C
Summary of Contents for Panasonic KX-HDV230C
-
Page 1: Table Of Contents
Home PBXware SERVERware TELCOware SIPmon SIPProt Desktop & Mobile UADs Appliances From Bicom Systems Wiki Contents 1 Introduction 2 Requirements 2.1 Identifying Phone Model 2.2 Phone Firmware 2.3 DHCP Server 2.4 PBXware Version 3 Installation 3.1 Power Adapter 3.2 Power over Ethernet (PoE) 3.3 Find the Phone's IP Address 3.4 Reset to Factory Settings 4 Registering Phone... -
Page 2: Requirements
This Configuration Guide is written as a general guide on how to configure the Panasonic phone model KX-HDV230C to work with PBXware 5.3.8. Requirements Identifying Phone Model To start and successfully complete the registration of your Panasonic phone, you need to know which phone model to set up. -
Page 3: Dhcp Server
DHCP Server Fully configured and operational DHCP server. PBXware Version PBXware Version 5.3.8 In order to find out the PBXware version: Log in to PBXware Navigate to Settings: About. On the top of the About page is a code similar to this one Edition: Multi-Tenant, Release: 5.3.8.0 (2223ce45), Running: 13.23.1-gc-040bbaca, Proxy v5.3.8 (231c5f3), API: 5.3, libmemcached version: 1.0.18, where 'Release' denotes the exact version of PBXware. -
Page 4: Find The Phone's Ip Address
Do not unplug or remove power to the phone while it is updating firmware and configuration. Registering Phone This section describes how to identify the Panasonic phone model, requirements that must be met and how to register the phone using manual configuration or auto provisioning. The following topics are covered:... - Page 5 UAD Settings Navigate to Settings:UAD. Make sure Panasonic UAD is enabled. To check the UAD status, click the Edit icon corresponding to the Panasonic phone. Make sure Status is set to Active, Auto provisioning is set to No, and DHCP is set to Yes.
- Page 6 Department to which this Extension belongs. Example: Sales. Click the Save button. Registering a Phone This section describes how to register a Panasonic phone using Hostname or IP Address. Hostname or IP Address Log in to the phone's web administration interface Open a new browser window and enter the phone's IP address in order to access the phone's web administration interface login screen.
-
Page 7: Auto Provisioning
Proxy Server Address Same as the Registrar Server Address. Authentication ID PBXware Extension number. Example: 1003 Authentication Password The Secret of the Extension as received in the e-mail associated with this Extension. Example: _%Z4M3*Ts9y7. A password is generated automatically for each newly created Extension. - Page 8 Make sure Panasonic UAD is enabled. To check the UAD status, click the Edit icon corresponding to the Panasonic phone. Make sure Status is set to Active, Auto provisioning is set to Yes, and DHCP is set to Yes. Click the Save button to save changes.
- Page 9 Click the Save button. Registering a Phone This section describes how to register a Panasonic phone using DHCP, TFTP or HTTP. The following topics are covered: DHCP TFTP or HTTP DHCP...
- Page 10 Example of an IP Address using HTTP: http://username:password@192.168.1.1/prov/{mac}.cfg Enter the Auto Provisioning username and password into the Authentication ID and Authentication Password fields. If you choose to use server type TFTP, enter tftp:// followed by Hostname or IP Address Example of a Hostname: tftp://192.168.1.136/{mac}.cfg Example of a IP Address: tftp://192.168.1.136/{mac}.cfg Click the Save button.