Table of Contents
Advertisement
Functions
The reset button has the following functions:
• Restart of the device
To restart the device, press the reset button briefly.
Note
If you make changes to the configuration and restart immediately afterwards with the
reset button, the changes may be lost. If you restart the device using the WBM (menu
command "System > Restart") or using the CLI (command "restart" in the Privileged EXEC
Modus), the configuration changes are always retained.
• Loading new firmware
If the normal procedure with the "Load & Save" menu of Web Based Management is
unsuccessful, the reset button can be used to load new firmware. This situation can occur
if there is a power outage during the normal firmware update. For more detailed
information, refer to section "Upkeep and maintenance (Page 59)".
• Restoring the default parameters (factory defaults)
For more detailed information, refer to section "Upkeep and maintenance (Page 59)".
NOTICE
Previous settings
If you reset, all the changes you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network with
further consequences.
3.7
CLP
The CLP (Configuration License PLUG) is used to transfer the configuration of the old device
to the new device when a device is replaced. The CLP is also referred to as PLUG in the
description.
The PLUG is available in the following variants:
• PLUG Configuration: The exchangeable storage medium only saves the configuration data
of the device.
• PLUG License: In addition to the configuration data, the removable data storage medium
also contains a license that allows the use of Siemens Remote Services.
SCALANCE MUM856-1
Operating Instructions, 08/2021, C79000-G8976-C628-02
Description of the device
3.7 CLP
27
Advertisement
Table of Contents
