Table of Contents
Advertisement
Time data selection
Displayed time data
Use the CTL/TC/UB button to select one of CTL
(control), time code, and user bit values. When you
select time code, the data displayed is determined by
the setting (LTC/AUTO/VITC) of the TC switch as
follows.
TC switch setting Displayed data
LTC
LTC recorded on tape
VITC
VITC recorded on tape
AUTO
LTC or VITC (automatically switched)
Output time code
The settings of the PRESET/REGEN switch and
extended menu item 606 determine whether the time
code output from the TIME CODE OUT connector is
the time code read by the internal time code reader
(REGEN), or the playback time code (PRESET).
For details of the PRESET/REGEN switch settings, see page
2-5.
4-2-2 Playback/Feed Play
Procedures
This section describes the following types of playback
which the unit can carry out:
• Normal playback
Playback at normal (×1) speed
• Playback in jog mode
Variable speed playback, with the speed determined
by the speed of turning the search dial
• Playback in shuttle mode
Variable speed playback, with the speed determined
by the angular position of the search dial
• Playback in variable mode
Variable speed playback, with the speed finely
determined by the angular position of the search dial
• Playback using the capstan override function
The playback speed is adjusted temporarily according
to the angular position of the search dial, to align the
playback phase with that of another VTR.
• Playback in feed mode
Playback at any speed selected in the range of 0.1 to
2 times normal speed. High-speed data transfer
through the SDTI OUTPUT connectors is possible.
• DMC Playback
Chapter 4 Recording and Playback
4-7
Advertisement
Table of Contents
