Table of Contents
Advertisement
4-2 Playback/Feed Play Procedures
4-2 Playback/Feed Play Procedures
This section describes the following types of playback
which the unit can carry out:
• Normal playback
Playback at normal (×1) speed
• Playback in jog mode
Variable speed playback, with the speed determined
by the speed of turning the search dial
• Playback in shuttle mode
Variable speed playback, with the speed determined
by the angular position of the search dial
• Playback in variable mode
Variable speed playback, with the speed finely
determined by the angular position of the search dial
• Playback using the capstan override function
The playback speed is adjusted temporarily according
to the angular position of the search dial, to align the
playback phase with that of another player or a VTR.
• Playback in feed mode
Playback at any speed selected in the range of 0.1 to
2 times normal speed. High-speed data transfer
through the SDTI OUTPUT connectors is possible.
• DMC Playback
4-2
Chapter 4 Playback
4-2-1 Normal Playback
First insert a cassette.
For details of how to insert a cassette, see Section 3-4-2,
"Inserting and Ejecting Cassettes" (page 3-7).
6
0
PLAY button
To start playback
Press the PLAY button.
Playback starts, the servo locks, and the SERVO
indicator lights.
To stop playback
Press the STOP button.
If you play back to the end of the tape
The tape is automatically rewound, and stops.
When using the Dolby noise reduction system
When using an analog Betacam cassette, you can use
Dolby C noise reduction for audio playback.
To activate the Dolby noise reduction system, set the
DOLBY NR switch on the subsidiary control panel to
ON.
Cassette compartment
%
9
)
p
STOP button
Advertisement
Table of Contents
