Table of Contents
Advertisement
5 COMPONENT VIDEO OUTPUT connectors
(BNC type)
These output analog component video signals (Y/R–Y/
B–Y).
3 Digital input/output section
1 SDI INPUT connectors
SDI
SDTI
OUTPUT
INPUT
1
OUTPUT
2
1
3
2
(SUPER)
2 SDI OUTPUT connectors
1 SDI (Serial Digital Interface) INPUT connectors
(BNC type)
Input D1 format digital video/audio signals. Of the
two connectors, the upper one is for input, and the
lower one is for a active-through connection.
2 SDI (Serial Digital Interface) OUTPUT
connectors (BNC type)
These output D1 format digital video/audio signals.
When the CHARACTER switch on the subsidiary
control panel is set to ON, connector 3 (SUPER)
outputs a signal with superimposed time code, menu
settings, alarm messages, and other text information.
3 SDTI (Serial Data Transport Interface)
OUTPUT connectors (BNC type) (for optional use)
These output SDTI (SX) or SDTI-CP video and audio
signals.
Using these connectors requires the optional BKNW-
118 SDTI (SX) Output Board or BKNW-124 SDTI-CP
Output Board.
4 Time code input/output section and
audio monitor signal output section
3 SDTI OUTPUT
connectors
1 TIME CODE IN connector (XLR 3-pin, female)
To record time code from an external device, input a
time code signal from the time code output connector
of the other device.
2 TIME CODE OUT connector (XLR 3-pin, male)
This outputs a time code according to the operating
state of the unit, as follows:
• During playback: the playback time code
By setting extended menu item 606, you can also
output the time code from the internal time code
generator locked to the playback time code.
• During recording: the time code generated by the
internal time code generator or the time code input to
the TIME CODE IN connector.
3 MONITOR OUTPUT connectors (XLR 3-pin,
male)
According to the setting of the audio signal selection
buttons (see page 2-4) on the upper control panel, two
(L and R) audio monitor signals are output.
1 TIME CODE IN connector
2 TIME CODE OUT connector
TIME CODE
IN
OUT
MONITOR OUTPUT
R
L
3 MONITOR OUTPUT connectors
Chapter 2 Location and Function of Parts
2-21
Advertisement
Table of Contents
