Agilent Technologies 90000 X Series User Manual page 45

3
4
Use the Trigger Setup dialog box to select any of the different modes of
triggering, the parameters and conditions for each trigger mode, and
advanced configuration items.
You can also click in the Set Trigger Level field to open a pop- up numeric
keypad so you can set a particular trigger level when the scope is set for
edge trigger on a particular channel. You can also use the up and down
arrows to the right of the setting, or click and drag the trigger reference
indicator at the right side of the display.
Agilent Infiniium 90000 X-Series Oscilloscopes User's Guide
Press the [Sweep] key until the Trig'd or Auto (select one) LED is lit.
When Trig'd is selected, the oscilloscope must find the trigger before
saving and displaying captured data.
When Auto is selected, if a trigger does not occur within a certain
amount of time, an acquisition is automatically saved and displayed. In
Auto trigger mode, you are able to see your signals while setting up the
desired trigger.
Turn the Level knob to adjust the voltage level at which the
oscilloscope will trigger.
Using the Oscilloscope
45
2