Troubleshooting - Precor Spinner Chrono S20 Getting Started Manual

Troubleshooting

Error Information
You cannot use
Serious error
the console
Console continues
Minor error
to function
Service Only occurs during
mode error USB access
Only detected
STUCK KEY
when the console
error
is powered up
Console Care
Important DO NOT use any acidic cleaners to clean the console. Doing so will weaken paint, powder coatings, and other
surface finishes and will void the Precor Limited Warranty. Never pour water or spray liquids directly onto the screen.
Precor strongly recommends performing the following maintenance after each use:
o Spray a mild soap solution in a 30:1 water-to-cleaner ratio onto a soft cloth, and then wipe the console. Never
spray liquids directly onto the console or use abrasive cloths, oil, ammonia, or alcohol-based cleaners.
o Inspect each console for loose parts or bolts, and adjust and tighten loose hardware as needed. Remove any
consoles that are dam
Spinner® Chrono™ Operator's Guide | P/N 304657-101 rev A, ENU
©2017 Precor Incorporated | March 2017
Error In error
displays? log?
Error
YES
number
NO YES
Error
NO
message
STUCK
NO
KEY
aged, not properly mounted, or at risk of coming loose.
ASL Possible Causes
Change?
• Connected to wrong lower
YES
Communication error
•
RPM sensor stops working or strain gauge fails
YES causing WATTS inaccuracy, but a functioning
console.
USB ACCESS – Unable to read USB stick
•
NO
• USB FILE – File structure error on USB stick
• USB SETUP – Error in program.ini or setup.ini
Appears if you hold key down for at least three
NO
seconds.