Trou Ble Shoot Ing Guide - Electro-Voice Telex RE-1 Operating Instructions Manual

Prob lem
No au dio and no display on the
re ceiver
No au dio and no RF signal indicator
on the receiver display
No Au dio with good RF signal indica-
tor but no (or low) Au dio indicator on
the re ceiver dis play
No (or low) Au dio with good RF sig-
nal and Au dio indicators on receiver
dis play
Dis torted au dio sig nal
Interference
Pos si ble Causes
Receiver is off
Trans mit ter is off
Transmitter is on a different channel
No (or dead) bat tery in transmitter
Faulty bat tery contacts
Mi cro phone not connected
Low gain setting on the transmitter
Receiver au dio output cable is dam-
aged or disconnected
Gain not sufficient on
mixer/preamp/amp in put or it is muted
Receiver output too low (1/4" out put)
Transmitter au dio gain too high
Receiver output too high (1/4" out put)
Loud in strument or au dio source
Battery level low in transmitter
An other CSR-1000 sys tem in the in-
stallation is on the same channel or the
signals are mix ing
Another wireless prod uct in the area is
on the same fre quency or the sig nals
are mixing
6-1
S

Trou ble Shoot ing Guide

So lu tions
Make sure that the power supply is
properly connected and the on/off but -
ton is in the on po sition
Turn on transmitter power switch
Match the transmitter group and chan-
nel to the one dis played on the re ceiver.
Insert fresh bat tery in transmitter
Clean and or bend contact
Check the TA4F con nector on the
bodypack or the detachable micro-
phone el e ment con nec tion on the
handheld
In crease the trans mit ter gain
Connect, re pair or re place ca ble
Increase gain on mixer or un-mute
the input
Increase the au dio output setting
Decrease the transmitter gain set ting
Decrease the re ceiver output set ting
Change the bodypack au dio mode
switch to Instrument set ting
Insert fresh bat tery in transmitter
Make sure all the chan nels in use are
from the same group. Use ClearScan
to se lect the clear est group. If more
channels are needed call Telex at
800-392-3497 for coordination help
Use ClearScan to change the op erat-
TM
ing frequency. If prob lems per sist, call
Telex at 800-392-3497 for co ordination
help
ection
6
TM