T O Create A Port Forwarding; Onsoles And Pc S , And Security C Rule - Motorola MG7540 User Manual

To Create a Port Forwarding Rule
1 Under Local IP Address, enter the address of the game station, PC
or other device. In the case of a security camera, enter the address
of the camera's DVR.
2 Under Local Start Port, enter the starting port that your device or
game needs.
3 Under Local End Port, if your device uses a sequential range of port
numbers, enter the highest number in the range. Otherwise, if there
is only one number, enter the start port number again.
4 Unless instructed otherwise in your game or device documentation,
leave the External entries blank. They will fill in automatically.
5 Select the protocol, TCP, UDP or Both, indicated in your
documentation.
6 Select Enable in the Enable/Disable pulldown.
7 Click Save.
Repeat these steps as necessary to create rules for multiple ports or port ranges.
The rule or rules you create will appear at the bottom of the page, as shown below.
Note that you can clear individual rules, or all rules.