Broan SPE1 Series Installation Use And Care Manual page 11

8 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Discard the tie
wrap.
9 ] Remove Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal
exhaust) of hood. For knockout removed from back of hood, install an appropriate strain
relief, 1/2" diameter (not included). For knockout removed from top of hood, the strain relief
will be installed later.
ELECTRICAL
POWER CABLE
KNOCKOUT
NON-DUCTED INSTALLATION ONLY
10 ] Remove the 3 screws retaining the recirculation cover plate to the hood. Discard this plate
with its screws.
11 ] Peel off and discard the membrane covering the recirculation grille, ensuring the openings
are totally cleared.
SCREWS
RECIRCULATION
COVER PLATE
EZ1
BRACKETS
11