Table of Contents
Advertisement
Components
1. Trim tab
2. Bolt
3. Cap
Bolt tightening torque:
42 Nm (4.28 kgf-m, 31.0 ft-lb)
EMU26342
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
32
1. Tilt support lever
ECM00661
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be
trailered in the normal running position,
use an additional support device to secure
it in the tilt position.
EMU26385
Cowling lock lever (pull up type)
To remove the engine top cowling, pull up the
cowling lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock
the cowling by moving the cowling lock le-
ver(s) downward.
1. Cowling lock lever(s)
1
ZMU07356
Advertisement
Table of Contents
