Inspecting And Replacing Anode(S) - Yamaha F150A2 Owner's Manual

Hide thumbs Also See for F150A2:
Table of Contents

Advertisement

1. Gear oil drain screw
2. Oil level plug
3. Gasket
TIP:
 If a magnetic gear oil drain screw is
equipped, remove all metal particles from
the screw before installing it.
 Always use new gaskets. Do not reuse the
removed gaskets.
4.
Remove the oil level plug and gasket to
allow the oil to drain completely.
NOTICE: Check the used gear oil after
it has been drained. If the gear oil is
milky or contains water or a large
amount of metal particles, the gear
case may be damaged. Have a
Yamaha dealer check and repair the
outboard motor.
TIP:
For disposal of used oil, consult your Yamaha
dealer.
5.
Put the outboard motor in a vertical posi-
tion. Using a flexible or pressurized filling
device, inject the gear oil into the gear oil
drain screw hole.
[ECM00714]
Recommended gear oil:
Yamalube Marine Gearcase Lube or
Hypoid gear oil
Recommended gear oil grade:
SAE 90 API GL-4
Gear oil quantity:
0.980 L (1.036 US qt, 0.862 Imp.qt)
6.
Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
Tightening torque:
9 Nm (0.92 kgf-m, 6.6 ft-lb)
7.
Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
Tightening torque:
9 Nm (0.92 kgf-m, 6.6 ft-lb)
EMU29317

Inspecting and replacing anode(s)

Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
Maintenance
83

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fl150a2F150Lf150

Table of Contents