Tires; Body, Deck, And Upholstery - Scag Power Equipment SPZ52-22FX Operator's Manual

Section 7
CAUTION
Inspect the cutter blade spacer(s) and washer
for wear and/or cupping. Replace the worn parts.
Worn spacer(s) and/or washer will not allow
proper tightening of the cutter blade and can lead
to cutter blade failure, personal injury or property
damage.
4. To install the new cutter blade, put the lockwasher
and flatwasher onto the blade bolt and slide the bolt
into the hole in the cutter blade.
CUTTER BLADE
LOCKWASHER
5/8-11 x 1-1/2" HEX HEAD BOLT
TORQUE TO 75 FT/LBS
Figure 7-9. Blade Replacement
- NOTE -
Be sure that the blade is installed with the lift wing
toward the top.
5. Install the cutter blade onto the cutter spindle shaft.
Secure the blades from rotating and torque to 75 ft/
lbs. See Figure 7-9.

7.9 TIRES

Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels
Drive Wheels
FLATWASHER
25 PSI
8
37

7.10 BODY, DECK, AND UPHOLSTERY

CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
1. After each use, wash the mower and cutter deck.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
2. Do not spray electrical components.
3. Use a mild soap solution or a vinyl/rubber cleaner to
clean the seat.
4. Repair damaged metal surfaces using Scag touch-
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.
R