Using The Remote Control; Setting Main Operating Mode; Setting Timer; Other Functions - Bosch Climate Line 5000 Operating Instructions For Users

Operation
3.3

Using the remote control

The signal range is 8 m. If objects are in the way or certain fluorescent lamps
are used in the same room this can affect transmission of the signal.
▶ Point the remote control towards the signal receiver window of the
unit and press the desired key.
The unit emits a beep when it receives a signal.
NOTICE
The remote control may be permanently prevented from working correctly.
▶ Do not expose the remote control to direct sunlight.
▶ Do not leave the remote control near a heating appliance.
▶ Protect the remote control from moisture and impacts.
3.4

Setting main operating mode

Switching on/off the unit
▶ Press the K key to switch the unit on or off:
The unit starts in the set operating mode.
Settings can also be made when the unit is switched off. The unit saves
the settings, and also retains them in the event of a power failure.
Automatic mode
In automatic mode, the unit automatically switches between heating and
cooling mode to maintain the desired temperature.
▶ Press Mode key repeatedly until
▶ Select the required temperature with the . and / keys.
The fan speed cannot be adjusted in automatic mode.
Cooling mode
▶ Press Mode key repeatedly until
▶ Press the key until the required air speed is reached.
▶ Select the required temperature with the . and / keys.
Fan (Only) mode
▶ Press Mode key repeatedly until
▶ Press the key until the required fan speed is reached.
AUTO can be selected to enable automatic control.
The temperature cannot be adjusted or displayed in fan mode.
Dehumidification mode
▶ Press Mode key repeatedly until
▶ Set the required temperature with the . and / keys.
The fan speed cannot be adjusted in dehumidification mode.
Heating mode
▶ Press Mode key repeatedly until
▶ Set the required temperature with the . and / keys.
▶ Press the key until the required fan speed is reached.
If the outside temperature is very low, the heating capacity of the air
conditioning system may not be sufficient. We recommend connecting
additional heat sources.
6
appears on the display.
appears on the display.
appears on the display.
appears on the display.
appears on the display.
3.5

Setting timer

ON and OFF timers can be set to between 0 and 24 hours, in 30-minute
increments for the first 10 hours, then in 1-hour increments. If 0 hours is
set, the timer is cancelled.
Setting the on timer
▶ Press the key until the
▶ Press the . or / key to set the desired time.
The setting is applied shortly afterwards.
Setting the off timer
▶ Press the key until the
▶ Press the . or / key to set the desired time.
The setting is applied shortly afterwards.
Cancelling timer
▶ Press the key to select the corresponding timer.
▶ Set 0.0 hours.
The timer is cancelled after a short time.
Combining timers
The two timers can be set at the same time. Either timer can be
programmed to activate prior to the other
▶ Set the on timer and off timer.
The settings will be automatically combined.
Current time
Setting of ON timer
Setting of OFF timer
Switch-on time
Switch-off time
Table 9 Example
You can not program the on timer and off timer to operate the unit at
different temperatures or with other settings.
3.6

Other functions

3.6.1

Setting the swing function

NOTICE
If the louver remains at the lowest position during cooling mode for an
extended period, condensate may form. Adjusting the louver by hand
may cause faults.
▶ Only use the remote control to adjust the louver.
Automatic vertical swing mode (up/down)
▶ Press the Swing key until the symbol
▶ To cancel the automatic vertical Swing mode: press the Swing
key again.
Swivelling the louver manually (up/down)
▶ Press the Swing key until the required position is set.
The setting changes in the following sequence:
Automatic horizontal swing mode (left/right)
▶ Press the Swing key for longer than 2 seconds to activate the
automatic horizontal Swing mode.
The remote control displays the symbol
▶ To cancel the automatic horizontal Swing mode: press the Swing
key again.
Climate Line 5000 – 6721831691 (2021/02)
symbol appears.
symbol appears.
13:00 o'clock
4.0 h
8.5 h
17:00 o'clock
21:30 o'clock
appears.
.