Denon AVR-X2700H Owner's Manual page 237

Contents Connections
Audyssey MultEQ ® XT, Audyssey Dynamic EQ
These cannot be selected when you have not performed Audyssey
0
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 120)
0
These cannot be selected when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name.
0
These cannot be selected when using the headphones.
0
"Restorer" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "Restorer" cannot be used. (v p. 157)
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 120)
0
No sound is output when using ZONE2.
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
0
range of about 98.4 ft/30 m.
Sound mode settings are not available when using Bluetooth headphones. Audio menu settings are also not available.
This unit cannot change sound mode or audio menu settings for audio output to Bluetooth headphones.
0
Front panel Display
Playback
® and Audyssey Dynamic Volume
Setup. (v p. 183)
®
237
Rear panel
Settings Tips
® cannot be selected.
Remote Index
Appendix