Denon AVR-X2700H Owner's Manual page 178

Contents Connections
HDCP Setup
Sets the HDCP version for each HDMI input source.
Video may not be output depending on the HDCP version of your player
and the TV.
If this issue occurs, use this setting to set one version of HDCP. This may
be able to output video.
Auto Automatically applies the HDCP version of
(Default): this unit according to TV.
1.4: Fixes the HDCP version of this unit to 1.4.
2.3: Fixes the HDCP version of this unit to 2.3.
0 "Custom" is displayed for the setting item if our service engineers or custom
installers has configured the HDCP version for this unit.
Front panel Display
Playback Settings
TV Format
Set the video signal format to be output for the TV you are using.
o Format
NTSC
(Default):
PAL:
0 "Format" can also be set by the following procedure. However, the menu
screen is not displayed. Following the display content to make the setting.
1. Press and hold the main unit's ZONE2 SOURCE and STATUS at the same
2. Use the main unit's TUNER PRESET CH + or TUNER PRESET CH – and
3. Press the main unit's STATUS to complete the setting.
NOTE
0 When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
178
Rear panel
Tips
Select NTSC output.
Select PAL output.
time for at least 3 seconds.
"V.Format:<NTSC>" appears on the display.
set the video signal format.
Remote Index
Appendix