Table of Contents
Advertisement
User's Guide
Light
Situation
When the power is on or flashing
❏ The printer was not turned off correctly.*
❏ Because the printer was turned off while
operating, the nozzles may have dried
and clogged.
* The power was turned off with a power
strip or breaker, the plug was pulled out of
the outlet, or an electrical failure occurred.
When the power is off
The printer has started in recovery mode
because the firmware update failed.
Flashing simultaneously
The printer cover is open.
Flashing simultaneously
The output switch lever is lowered.
Flashing simultaneously
The output switch lever is raised.
Flashing alternately
A maintenance box is nearing or at the end
of its service life.
A printer error has occurred.
Related Information
"Removing Jammed Paper" on page 77
&
"Contacting Epson Support" on page 100
&
"Installing Applications" on page 72
&
Checking the Printer Status - Windows
1. Access the printer driver window.
Solving Problems
Solutions
❏ After clearing the error by pressing the
we recommend performing a nozzle check. Cancel
any pending print jobs.
❏ To turn off the printer, make sure you press the
button.
Follow the steps below to try to update the firmware
again.
1. Connect the computer and the printer with a USB
cable.
2. Visit your local Epson website for further
instructions.
Close the printer cover until it clicks.
Raise the output switch lever.
Open the paper cassette cover, and then lower the
output switch lever.
The maintenance box needs to be replaced.
When a message saying that you can continue
printing is displayed on the computer, press the
button to continue printing. The lights stop flashing
for the time being, however, they will continue to
flash at regular intervals until the maintenance box is
replaced.
Open the printer cover and remove any paper inside
the printer. Turn the power off and on again.
If the error continues to occur after turning the power
off and on again, contact Epson support.
76
button,
P
Advertisement
Table of Contents
