Fan Only Mode; Heat Mode (Hs Model Only); Fan Speed - EdgeStar AP14000HS Owner's Manual

Fan Only Mode

NOTE: Fan Only mode does
not require that the exhaust
hose be attached.

Heat Mode (HS Model Only)

NOTE: The exhaust hose must
be used in Heating Mode

Fan Speed

EdgeStar Portable Air Conditioner
Fan Only mode is used to circulate the air in your room. No
temperature setting is needed.
To operate the unit in Fan Only mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the
3) Press the Mode button until the
selected.
4) Press the Speed button to select the fan speed.
You can choose between
The AP14000HS model portable air conditioner can work as a heat
pump. It must be vented for it to expel the cold air out the exhaust.
To operate the unit in heat mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the
3) Press the Mode button until the
selected.
4) Select the fan speed by using the
5) Change the set temperature by using the
buttons. The temperature is adjustable between 61°F - 80°F in one
degree increments. You can switch between Fahrenheit and
Celsius by pressing the
The Fan Speed button is used to change the fan speed while
in Cooling, Fan Only and Heating (HS Model only) modes.
Press the Fan Speed button to select the fan speed.
You can choose between
Note: Although the remote control will allow you to set the fan
speed in Dehumidify mode, the unit will not actually change the fan
speed.
Power button on the remote control.
Low, Medium and
Power button on the remote control.
Speed button.
button.
Low, Medium and
Fan Only indicator is
High speed.
Heat indicator is
Up and Down
High speed.
16