Janome CoverPro 3000 Instruction Book page 18

b
i
o
n m
!1
, .
!4
⁄0
!2
!0
!5
!3
15
b Turn the handwheel toward you several times to align
the eye of the looper take-up lever and both guide
holes.
Pass the thread through the eye of the looper take-up
lever and both guide holes.
i Looper take-up lever
o Guide holes
n Slip the thread behind looper thread guide (B) from
the right.
!0 Looper thread guide (B)
m Pull the looper release knob and the looper will slant
to the right for easy access.
!1 Looper release knob
!2 Looper
, Pass the thread through the eye of looper thread
guide (C) then through the eye of looper.
Draw the thread end 4˝ (10 cm) to the back.
!3 Looper thread guide (C)
!4 Eye of the looper
NOTE:
You may use a pair of tweezers.
!5 Tweezers
. Push the looper in the direction of the arrow, back to
the original position.
⁄0 Close the looper cover.