Setting The Thread Guide Bar; Setting The Spools - Janome CoverPro 3000 Instruction Book

w
w
e
w
w
t

Setting the Thread Guide Bar

Pull the thread guide bar up as far as it will go.
q
Turn the thread guide post so that the thread guides are
e
right above the spool pins.
t
r

Setting the Spools

You can use two types of spools for this machine.
Spool cones
When using spool cones, attach the spool holders to the
spool pins.
If the thread slips down from a spool cone during the
threading and/or sewing, put the net over the spool cone
as shown to prevent jamming.
q
q
u
y
r
11
q Thread guide bar
w Thread guide post
e Thread guide
r Spool pin
t Stoppers
NOTE:
Be sure to snap both stoppers into places.
q Spool cone
w Spool holder
e Net
NOTE:
If the spool cone is unstable, insert the spool holder
into the spool cone all the way before setting it to the
spool pin.
Small spools
When using small spools, remove the spool holders from
the spool pins.
w Spool holder
r Small spool of thread
t Spool pin
Place the spool with its slit side up, and put the spool
holder cap on top of it.
y Slit
u Spool holder cap