Cooling Overload Operation - Mitsubishi Heavy Industries FDT100VNP1VF2 Technical Manual

Error code
Remote control: E35
1. Applicable model
All models
2. Error detection method
Anomalous stop
Reset
53(51) 60(56)
Outdoor heat exchanger temperature (°C)
Note (1) Values in ( ) are appli-
cable when outdoor
temperature (TH2) is
lower than 31 °C
3. Condition of error displayed
When anomalous outdoor heat
exchanger temperature occurs
5 times within 60 minutes or
60(56)°C or higher continues
for 10 minutes, including the
compressor stop.
4. Presumable cause
• Defective outdoor heat
exchanger temperature sensor
• Defective outdoor control PCB
• Indoor, outdoor unit
installation spaces
• Short-circuit of air on indoor,
outdoor units
• Fouling, clogging of heat
exchanger
• Excessive refrigerant quantity
Note:
LED Green Red
Indoor Keeps flashing Stays OFF
5. Troubleshooting
Diagnosis
Are normal
the characteristics of
outdoor heat exchanger
temperature sensor
normal?
YES
Is the
unit operating in
the state of cooling
overload?
NO
Is the high
pressure control
normal
YES
Is
the temperature
(measured actually) at
direction of error
correct?
* For the contents of control, refer to the protective control by controlling
compressor rotation speed and cooling high pressure protective control of
micro computer control function for corresponding models.
187
-
Content

Cooling overload operation

* For the characteristics of outdoor
heat exchanger temperature
sensor, refer to E37.
NO
YES
NO
NO
YES
-
'16 • PAC-T-240
Countermeasure
Replace outdoor heat
exchanger temperature
sensor.
Check unit side.
• Isn't the air circulation
of outdoor unit short-
circuited?
• Are installation spaces
adequate?
• Isn't there any fouling
or clogging on heater
exchanger?
Control operation check*
Defective outdoor control
PCB ➞ Replace.
Excessive refrigerant
amount: Recharge
refrigerant by weighing
proper amount on a scale.