Asko W6124X.W.U Instructions For Use Manual page 13

ADJUSTING THE FEET
Place the washing machine so that it is stable.
It is important that the machine is level to prevent
excessive vibrations during spin cycles. Each foot
of the washer is adjustable, so you can level the
washer on any surface. Once it is level, securely
tighten the lock nuts on the feet to prevent excessive
vibration during spin cycles.
1. Level the washing machine horizontally and
vertically by rotating the adjustable feet (using a
No. 32 (1.26") spanner).
The feet allow levelling by +/- 1 cm (0.39").
2. When the appropriate height of feet is set, use the
wrench No. 17 (0.67") to fi rmly fasten the counter-
nuts towards the bottom of the appliance
3. Tighten the jam nuts (counter nuts) to the end
position.
This will reduce washing machine noise, vibration,
movement etc. to minimum.
.
1
2
3
Customer Care Center, 1-800-898-1879, www.askona.com
MOVING THE WASHING MACHINE AND
TRANSPORT AFTER INSTALLATION
If you are moving the washing machine without
packaging, open the washing machine door and pull
the appliance by holding the washing assembly, as
indicated in the fi gure.
For any further moving of the appliance, use the
transport rods (the washing machine drum has to be
blocked).
(See chapter TRANSPORT PROTECTION.)
13