Manual Mode; Specifications; Troubleshooting Guide - Heath Zenith 5838 Manual

Manual mode overrides the motion sensor and "ON-TIME"
control so the light will operate full bright. This feature only
works at night and only for one night at a time. The motion
sensor will reset to motion sensing mode after 6 hours or
sunrise, whichever comes first. Manual mode can be toggled
on and off using a wall switch. Note: If the power to the
light fixture is off for more than 5 seconds, allow the mo-
tion sensor to warm up prior to switching to manual mode.
• Ensure the power to the light is ON and the sensor has
warmed up (60 seconds).
• To turn manual mode on, switch the power OFF–ON–OFF–ON at the wall switch within 3 seconds.
• To turn manual mode off, switch the power OFF–ON–OFF–ON at the wall switch within 3 seconds.
IMPORTANT: If manual mode does not turn ON or OFF, use a slower pace turning the power ON and OFF at the wall
switch while staying within 3 seconds.
Range ...................................................Up to 70 ft. (21 m) [varies with surrounding temperature].
Sensing Angle.......................................Up to 240°
Power Requirements .............................120 VAC, 60 Hz
Electrical load .......................................34 Watts
Operating Modes .................................TEST, MOTION ACTIVATED, and MANUAL MODE
ON-Timer ............................................1, 5, 20 minutes
Test Timer ............................................5 Seconds
Manual Mode Timer ............................Maximum 6 Hours
Sensitivity (SENS) ..............................."L", "M", "H"
LED Lumens .......................................2600
SYMPTOM
The light will not come on.
The light comes on during
the day.
6

MANUAL MODE

SPECIFICATIONS

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
1. Light switch is turned off.
2. Fuse is blown or circuit breaker is turned off.
3. Daylight turn-off (photocell) is in effect.
4. The circuit wiring is incorrect, if this is a new
installation.
5. The motion sensor is aimed in the wrong
direction.
6. The outside air temperature is close to the
same as a person's body heat.
1. The motion sensor may be installed in a
relatively dark location.
2. The "ON-TIME" switch is in the "TEST"
position.
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
OFF ON
Less than 3 seconds
SOLUTION
1. Turn light switch on.
2. Replace fuse or turn circuit breaker on.
3. Recheck after dark.
4. Verify wiring is correct.
5. Re-aim the motion sensor to cover the
desired area.
6. Increase the "SENS" setting. See Seasonal
Changes on page 5 for more information.
1. The light fixture is operating normally under
these circumstances.
2. Set the "ON-TIME" switch to the 1, 5, or 20
minute setting.
OFF ON
210008-02