Troubleshooting - Husky HDUFL50 Manual

TROUBLE SHOOTING
WARNING:
!
Stop using tool immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a qualified service person or an
authorized service center.
PROBLEMS POSSIBLE CAUSES
Air leaking in head cap. ⒈Loose screws.
⒉Worn or damaged O-rings or seals.
Lack of power. ⒈Tool is too dry.
Slow to cycle. ⒉ Air pressure too low.
⒊ Exhaust blocked.
Not shooting fasteners . ⒈Damaged pusher spring.
⒉ Wrong size of fasteners.
Fasteners are ⒈Drive channel is worn.
jammed in the tool ⒉ Piston is broken or worn.
frequently. ⒊ Bent fasteners.
⒋ Dirty magazine.
⒌ Loose magazine.
⒍ Wrong fasteners.
12
CORRECTION ACTIONS
⒈Tighten screws.
⒉ Install overhaul kit.
⒈Add about 2-3 drops of
lubrication into the air connector.
⒉Make sure the air compressor
is set between 70psi and 115psi.
⒊ Clean exhaust channel.
⒈Replace spring.
⒉Use 1/2" crown staples or
1-1/2" to 2"nails.
⒈Fix the drive channel.
⒉ Replace the piston.
⒊ Remove the bent fasteners,
replace with the 1/2"crown
staples or 1-1/2" to 2"nails.
⒋ Clean magazine.
⒌ Tighten screws.
⒍ Verify that fasteners are the
correct size.
WARRANTY
2 YEARS LIMITED WARRANTY
If within two years from the date of purchase, this Husky air tool product fails due to a defect
in materials or workmanship, please immediately contact Product Support at 1-888-669-
5672 (8am to 5pm EST, M-F, except normal Holiday).Do not return the air tool to the store.
Please be prepared to send the product, postage prepaid, along with a copy of the dated
first owner purchase receipt with the tool model to: PRIME GLOBAL PRODUCTS, INC.
Address:201 Ropemill Parkway, suite#1, Woodstock, GA. 30188. A defective product
will be promptly replaced with a
warranty excludes incidental/consequential damages and failures due to misuse,
abuse or normal wear and tear. This warranty gives you specific rights, and you
may also have other rights, which vary, from state to state. Please call
details.
new one of equal or greater value. This
1-888-669-5672 for
13