Servicing The Engine - Exmark LAZER Z XS Setup Instructions

Percent
Voltage
Reading Charge
12.6 or 100%
greater
12.4 – 12.6 75–100%
12.2 – 12.4 50–75%
12.0–12.2 25–50%
11.7–12.0 0–25%
11.7 or less 0%
If the ignition is in the "ON" position there
is potential for sparks and engagement of
components. Sparks could cause an explosion
or moving parts could accidentally engage
causing personal injury
Be sure ignition switch is in the "OFF" position
before charging the battery.
3. Connect the negative battery cables.
Note: If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black) cable
to the negative battery terminal. Slip insulator boot
over the positive terminal.
Note: If time does not permit charging the battery,
or if charging equipment is not available, connect
the negative battery cables and run the vehicle
continuously for 20 to 30 minutes to sufficiently
charge the battery.
Positioning the Discharge Chute
Loosen two 5/16 inch nyloc nuts attaching discharge
chute. Lower the discharge chute into position.
Retighten nyloc nuts until chute is snug but can pivot
freely.

Servicing the Engine

Refer to Engine Owner's Manual.
Maximum Charging
Charger Interval
Settings
No Charging
16 volts/7
amps Required
30 Minutes
16 volts/7
amps
1 Hour
16 volts/7
amps
2 Hours
14.4 volts/4
amps
3 Hours
14.4 volts/4
amps
6 Hours or
14.4 volts/2
More
amps
Caution
Servicing the Engine Coolant
The machine is shipped filled with engine coolant.
Discharge of hot pressurized coolant or
touching hot radiator and surrounding parts
can cause severe burns.
• Do not remove the radiator cap when the
engine is hot. Always allow the engine to
cool at least 15 minutes or until the radiator
cap is cool enough to touch without burning
your hand before removing the radiator cap.
• Do not touch radiator and surrounding parts
that are hot.
Engine coolant is toxic. Swallowing engine
coolant can cause poisoning.
• Do not swallow engine coolant.
• Keep out of reach from children and pets.
With cool engine, check that coolant level is up to the
indicator line on the overflow bottle. If not, add 50/50
coolant mix to overflow bottle to bring the level up to
the indicator line. Also check coolant level in radiator.
Fill it as high as possible with 50/50 coolant mix.
Note: Units should only be filled with Dex Cool©
extended life coolant, which can be identified by its
orange color.
Servicing the Hydraulic Oil
The machine is shipped with hydraulic oil in the
reservoir.
1. Run the machine for approximately 15 minutes to
allow any extra air to purge out of the hydraulic
system.
2. Check hydraulic reservoir and if necessary fill the
reservoir to the appropriate level with Mobil 1
15W-50 synthetic motor oil.
3. Replace hydraulic reservoir cap and tighten until
snug. Do not overtighten.
Note: The baffle is labeled "HOT" and "COLD".
The oil level varies with the temperature of the oil.
The "HOT" level shows the level of oil when it is at
225°F (107°C). The "COLD" level shows the level of
the oil when it is at 75°F (24°C). Fill to the appropriate
4
Warning
Caution