Servicing The Engine - Exmark LAZER Z Series Setup Instructions

1. Motion control lever
2. 3/8 x 1 inch bolts
6. Align the levers front/rear position. With the levers
in the neutral position, loosen the hardware and
adjust the levers sliding and/or tilting the lever(s)
forward or backward until properly aligned and
tighten hardware (Figure 7).
7. If the ends of the levers hit against each other,
while in the drive position (levers rotated in as far as
possible), make adjustments by moving the levers
outwards to the neutral lock position and carefully
bending them outward. Move them back to the drive
position and check for clearance. Repeat if necessary.
1. Levers in alignment
Figure 6
3. Spring disc washers (cone
towards bolt head)
4. Control arm shaft
Figure 7
Positioning the Discharge Chute
Loosen two 5/16 inch nyloc nuts attaching discharge
chute. Lower the discharge chute into position.
Retighten nyloc nuts until chute is snug but can pivot
freely.

Servicing the Engine

Refer to Engine Owner's Manual.
Servicing the Hydraulic Oil
The machine is shipped with hydraulic oil in the
reservoir.
1. Run the machine for approximately 15 minutes to
allow any extra air to purge out of the hydraulic
system.
2. Check hydraulic reservoir and if necessary fill the
reservoir to the appropriate level with Mobil 1
15W-50 synthetic motor oil.
3. Replace hydraulic reservoir cap and tighten until
snug. Do not overtighten.
Note: The baffle is labeled "HOT" and "COLD".
The oil level varies with the temperature of the oil.
The "HOT" level shows the level of oil when it is at
225°F (107°C). The "COLD" level shows the level of
the oil when it is at 75°F (24°C). Fill to the appropriate
level depending upon the temperature of the oil. For
example: If the oil is about 150°F (65°C). Fill to halfway
between the "HOT" and "COLD" levels. If the oil is at
room temperature (about 75°F (24°C)), fill only to the
"COLD" level.
Filling Out the Warranty
Registration Form
Fill out warranty registration form and place keys into
literature pack.
6