Servicing The Engine - Exmark TURF TRACER HP Setup Instructions

Lubrication Chart
Fitting Initial
Locations Pumps
2
6. Pump Control
Bearings
7. Mower Deck 2
Idler Pivots
Number 4 (Pump Drive Idler Pivot) Located under
the engine deck.
Number 5 (Clutch Arm Pivot) Located under the
engine deck.
2. Lubricate the pivot point on PTO lever with a spray
penetrating lubricant.

Servicing the Engine

Refer to Engine Owner's Manual.
Servicing the Hydraulic Oil
The machine is shipped with hydraulic oil in the
reservoir.
1. Run the machine for approximately 15 minutes to
allow any extra air to purge out of the hydraulic
system.
2. Check hydraulic reservoir and if necessary fill the
reservoir to the appropriate level with Exmark
Premium Hydro oil.
3. Replace hydraulic reservoir cap and tighten until
snug. Do Not overtighten.
Note: The baffle is labeled "HOT" and "COLD".
The oil level varies with the temperature of the oil.
The "HOT" level shows the level of oil when it is at
225°F (107°C). The "COLD" level shows the level of
the oil when it is at 75°F (24°C). Fill to the appropriate
level depending upon the temperature of the oil. For
example: If the oil is about 150° F (65°C). Fill to halfway
Number of Service
Places Interval
2
40 hours
1 Yearly
Figure 8
between the "HOT" and "COLD" levels. If the oil is at
room temperature (about 75° F (24°C)), fill only to the
"COLD" level.
Filling Out the Product
Registration
Fill out the online warranty registration form and place
keys into literature pack.
7