Advertisement
Percent
Voltage
Reading
Charge
11.7–12.0
0–25%
0%
11.7 or less
CAUTION
If the ignition is in the "ON" position there
is potential for sparks and engagement of
components. Sparks could cause an explosion or
moving parts could accidentally engage causing
personal injury.
Be sure ignition switch is in the "OFF" position
before charging the battery.
2. Connect the negative battery cable.
Note: If the positive cable is also disconnected,
connect the positive (red) cable to the positive
battery terminal first, then the negative (black) cable
to the negative battery terminal. Slip insulator boot
over the positive terminal.
Note: If time does not permit charging the battery,
or if charging equipment is not available, connect
the negative battery cable and run the vehicle
continuously for 20 to 30 minutes to sufficiently
charge the battery.
Checking Tire Pressure
1. Check the tire pressure in the drive tires. Proper
inflation for drive tires is 12-16 psi (83-110 kPa).
2. Adjust the tire pressure within 12-16 psi (83-110
kPa) range to make the tire circumferences match as
closely as possible.
Greasing the Unit
Note: The unit is not greased at the factory.
1. Lubricate fittings with NGLI grade #2
multi-purpose gun grease. Refer to the following
chart and Figure 8 for fitting locations and initial
pumps.
Lubrication Chart
Fitting
Initial
Locations
Pumps
1. Front Caster
12
Wheel Bearings
2. Front Caster
2
Pivots
Maximum
Charging
Charger
Interval
Settings
3 Hours
14.4 volts/4
amps
6 Hours or
14.4 volts/2
More
amps
Number of
Service
Places
Interval
2
Daily
2
Daily
Lubrication Chart
Fitting
Initial
Locations
Pumps
3. PTO
Engagement
Bellcrank
4. Pump Drive
Idler Pivot
5. Clutch Arm
Pivot
6. Pump Control
Bearings
7. Mower Deck
Idler Pivots
Number 4 (Pump Drive Idler Pivot) Located under
the engine deck.
Number 5 (Clutch Arm Pivot) Located under the
engine deck.
2. Lubricate the pivot point on PTO lever with a spray
penetrating lubricant.
Servicing the Engine
The engine is shipped with oil; check oil level and if
necessary fill to the appropriate level. Exmark 4-Cycle
Premium Engine Oil is recommended. Refer to the
Engine Owner's Manual for an acceptable alternative.
Servicing the Hydraulic Oil
The machine is shipped with hydraulic oil in the
reservoir.
1. Run the machine for approximately 15 minutes to
allow any extra air to purge out of the hydraulic
system.
6
Number of
Places
1
1
2
1
1
1
2
2
2
1
Figure 8
Service
Interval
40 hours
Yearly
40 hours
40 hours
Yearly
Advertisement
