Single CSM and TSM Configuration
This configuration can be cabled as either a Single (Joined) SCSI Bus or
as a Dual (Split) SCSI Bus configuration.
Cabling the single (joined) SCSI bus configuration
One host cable is required for this configuration. The length of the
host cable may be a maximum of 25 meters in length. When viewed
from the rear there should be a CSM installed in one I/O slot and a TSM
in the other.
Follow the procedures below to connect the cable (see figure below):
1.
Power off the enclosure and the host system.
2.
Attach one end of the cable to the connector on the CSM.
3.
Attach the other end of this cable to the host.
To Host
ID 7
CSM
The CSM and TSM can be in either I/O slot of the enclosure.
SCSI ID Assignments shown from front of enclosure.
Note: For information on the host connectors, refer to the
documentation supplied with it.
1
2
Mute
25
1
2
TSM