List Mode - UNI-T UTL8500 Series User Manual

back and forth between the lower current and the upper current.
Rise Slope
Operation Steps:
1. In initial interface, select [Mode], and then press [Dynamic] to enter the setting interface
of <Dynamic Mode>.
2. Move the cursor to the needed setting position by pulse knob, and press the Enter
button to change the parameter (the parameter changes from yellow to white) by
keyboard or pulse knob. Press the Enter button
set value changes from white to yellow.
3. Other parameters can be modified in a similar way.
4. Press the ON button, the electronic load starts to load, and the indicator light below the
button lights up. If you need to stop the load, press the ON button again, and the
running indicator light goes out.

4.2.2 List Mode

The list test function can switch between different modes according to the set parameters.
For power products and charger devices, through multi-parameter mixed test, you can
have a more comprehensive and in-depth understanding of the operating characteristics
of the tested product in actual applications. The setting interface of list mode is shown in
Figure 4-2-2 below.
Upper Value
Fall Slope
Lower Value
Upper Duration
Lower Duration
One Cycle
Figure 4-2-1-2 Dynamic Mode
24
UTL8500 Series User Manual
again to confirm. At this time, the