Removing An Expansion Card From Expansion Card Riser 2 Or 3 - Dell PowerEdge E31S Series Owner's Manual
Hide thumbs
Also See for PowerEdge E31S Series:
- Owner's manual (164 pages) ,
- Owner's manual (32 pages) ,
- Owner's manual (121 pages)
Table of Contents
Advertisement
Table 41. Expansion card installation order (continued)
Card priority
Card type
GPU (single width)
2
RAID H830
RAID H830 (low profile)
100G Intel Omni-Path Architecture Host (OPA)
Channel Adapters (HCA)
14 Gb InfiniBand, Fourteen Data Rate (FDR) HCA
40 Gb NICs (full height)
3
40 Gb NICs (low profile)
25 Gb NICs (full height)
25 Gb NICs (low profile)
4
FC16 HBA (full height)
FC16 HBA (low profile)
5
10 Gb NICs (full height)
10 Gb NICs (low profile)
6
FC8 HBA (full height)
FC8 HBA (low profile)
7
1 Gb NICs (full height)
1 Gb NICs (low profile)
8
12 Gb SAS (low profile)
12 Gb SAS (full height)
9
Integrated RAID
10
NDC
NOTE:
Ensure that the 100 G OPA x16 card is installed in slot 6 (x16 PCIe) on the alternate riser 3.
Removing an expansion card from expansion card riser 2 or 3
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. When removing a card from riser 3, ensure that the PCIe holder latch is closed.
NOTE:
The procedure for installing and removing a full length PCIe card is similar to the procedure for removing and
installing a GPU card.
Steps
1. Disconnect any cables connected to the expansion card.
2. Lift the expansion card latch out of the guide slot.
3. Hold the expansion card by its edges, and remove it from the expansion card connector.
106
Installing and removing system components
Slot priority
Max allowed
6, 4, 7, 5
4
7, 6, 4, 5
2
3, 2
2
4, 6
2
3, 2, 1
3
5, 7, 4, 6
4
3, 2, 1
3
4, 6, 5
3
3, 2, 1
3
5, 7, 4, 6
4
2, 3, 1
3
5, 7, 4, 6
4
2, 3, 1
3
5, 7, 4, 6
4
2, 3, 1
3
5, 7, 4, 6
4
2, 3, 1
3
3, 2, 1
2
6, 4, 5, 7
2
integrated slot
1
integrated slot
1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
