ZyXEL Communications VMG9827-B50A User Manual page 83

Figure 32 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge Mode)
The following table describes the fields in this screen.
Table 14 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge Mode)
LABEL DESCRIPTION
General
Select Enable or Disable to activate or deactivate the interface.
Active
Name Enter a service name of the connection.
Type Select ADSL over ATM as the interface that you want to configure. The VMG uses the ADSL
technology for data transmission over the DSL port.
Mode Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you select
Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic
from the selected LAN port(s).
ATM PVC Configuration (These fields appear when the Type is set to ADSL over ATM.)
VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM
traffic). Enter the VCI assigned to you.
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User's Guide
Chapter 6 Broadband
83