Omron NA5-15W101S-V1 User Manual page 53

• Connecting Devices That Support IEEE 802.3i (10BASE-T) or IEEE 802.3u (100BASE-TX)
Pin No.
• Connecting Devices That Support IEEE 802.3ab (1000Base-T)
Pin No.
If you use a cable with a hood or boot, make sure that the mating length is at least 15 mm, as shown
in the following figure.
15 mm min.
• Ethernet Port Indicators
Indicator
LINK
ACT
NA-series Programmable Terminal Hardware(-V1) User's Manual (V125)
Signal name
1 TD+
2 TD-
3 RD+
4 BI D+
5 BI D-
6 RD-
7 BI D+
8 BI D-
Signal name
1 TRD0+
2 TRD0-
3 TRD1+
4 TRD2+
5 TRD2-
6 TRD1-
7 TRD3+
8 TRD3-
Color Status
--- Not lit.
Green Lit.
--- Not lit.
Orange Flashing.
Twisted-pair output (differential output)
Twisted-pair output (differential output)
Twisted-pair input (differential input)
Protection circuit
Protection circuit
Twisted-pair input (differential input)
Protection circuit
Protection circuit
Send/receive data 0+
Send/receive data 0-
Send/receive data 1+
Send/receive data 2+
Send/receive data 2-
Send/receive data 1-
Send/receive data 3+
Send/receive data 3-
Description
A link was not established.
• The cable is not connected.
• The power supply is OFF or the NA Unit was reset.
The link was established.
The link is on standby.
Data is being sent or received.
2 Configuration Units
Name
Name
2 - 7
2