Table of Contents
Advertisement
Specifications and Agency Compliance
Specifications
Operating temperature
Storage temperature
Storage and operating humidity range
Voltage
Receiver power consumption
Housing material
Mounting
(a)
Range
Output power
Radio frequency
Radio channels
Address range
Mounting
Wireless protocol
Agency compliance
United States
BAS-SVX40B-EN
-40 to 158ºF (-40 to 70ºC)
-40 to 185ºF (-40 to 85°C)
5% to 95% relative humidity (RH), non-condensing
24 Vac/Vdc nominal ± 10%
If using 24 Vac, polarity must be maintained.
<2.5 VA
Polycarbonate/ABS (suitable for plenum mounting), UV protected,
UL 94: 5 VA flammability rating
3.2 in (83 mm) with 2 supplied mounting screws
Open range: 2,500 ft (762 m) with packet error rate of 2%
Indoor: Typical range is 200 ft (61 mm); actual range is dependent on the environment.
See BAS-SVX55 for more detail.
North America: 100 mW
2.4 GHz (IEEE Std 802.15.4-2003 compliant) (2405–2480 MHz, 5 MHz spacing)
16
Group 0–8
Network 1–9
Fits a standard 2 in. by 4 in. junction box (vertical mount only). Mounting holes are spaced
3.2 in. (83 mm) apart on vertical center line. Includes mounting screws for junction box
or wall anchors for sheet-rock walls. Overall dimensions: 2.9 in. (74 mm) by 4.7 in.
(119 mm)
ZigBee PRO—ZigBee Building Automation Profile, ANSI/ASHRAE Standard 135-2008
Addendum q (BACnet™/ZigBee)
UL listed: UL 94, 5 VA flammability rating and UL916.
Energy Management Equipment FCC CFR47, Sec. 15.247 & subpart E, Digital Modulation
Transmission with no SAR (FCC ID: TPF-251701).
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the manufacturer for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
General Information
7
Advertisement
Table of Contents
