Table of Contents
Advertisement
Establishing the Network
Three Ways to Establish a Wireless Network
A wireless network can established:
•
•
•
Establishing the Network After Tracer SC Installation
If aTracer SC is installed prior to establishing the wireless network, the WCI that is installed on a
Tracer SC automatically becomes the network coordinator after power is applied to theTracer SC.
If multiple WCIs are installed on aTracer SC, each WCI forms an independent network for which
it is the coordinator.
Follow this procedure:
1. Observe the yellow CRD LED on the WCI illuminate to identify the WCI wired to theTracer SC
2. Observe the yellow OPEN_NET LED illuminate on the coordinator WCI.This LED remains lit for
3. Observe the green NWK LED illuminate:
4. After the network is formed, press the OPEN_NET button on the coordinator to close the
5. To enable and configureTracer SC for the new wireless network, seeTracer SC Online Help and
Establishing the Network Prior to Tracer SC Installation or Without Tracer SC Installation
If aTracer SC has not been installed at the time that you are ready to establish the network or will
never be installed on the network, follow this procedure to establish the network.
Task 1: Activate Communication Among Existing WCIs
1. Choose a centrally located WCI that has been wired to a unit controller to become the network
2. Press the START button for 5 seconds to establish the WCI as the coordinator and to open the
20
After aTracer SC has been installed.
Prior toTracer SC installation.
On a network that will not have aTracer SC installed on it.
as the network coordinator (see
1 hour, indicating that the network is open to allow WCIs with matching addresses to join the
network for that duration. After each WCI joins, the 1 hour timer starts over.
Note: If the network closes because the timer has expired, you can open the network for an
additional hour by pressing the OPEN_NET button on the network coordinator WCI.To
extend time on a network that has not yet closed, press the OPEN_NET button on the
coordinator to close the network, then press it again to open the network for an
additional hour. As an alternative, you can useTracerTU to open the network.
• On the coordinator WCI, indicating that it has joined its own network.
• On each additional WCI as it joins the network.
Note: Typically, it takes about 10 minutes for a WCI to join the network. However, the time is
dependent on the distance between the WCIs in network as well as the size and type of
structures that may exist between them.
network if it is still open (indicated by an illuminated OPEN_NET LED).
the current edition of theTracer SC System Controller Installation and Setup guide (BAS-
SVX31).
coordinator.
Note: This WCI will be network coordinator temporarily, if the network is to have aTracer SC
installed on it at a later time. At that time, the WCI that is installed on theTracer SC will
become the network coordinator.
network for joining.The yellow CRD LED on the WCI illuminates to identify the WCI as the
network coordinator (see
Figure 12, p.
18).
Figure 12, p.
18).
BAS-SVX40B-EN
Advertisement
Table of Contents
