Table of Contents
Advertisement
Assembly — Installing the Light Kit
Attaching the light kit to the
8
switch housing
NOTE: If you do not wish to install the light kit, skip steps 8
through 9 and proceed to step 10.
□
Remove the three light kit mounting screws (FF) from the
light kit (F) and keep these screws.
□
While holding the light kit (F) under your fan motor
assembly (B), locate two single white and blue wires in
the switch housing labeled "FOR LIGHT". Make the
polarized plug connections (QQ):
- White to white
- Blue to blue
□
Carefully push all wires back into the switch housing.
Install the light kit (F) onto the switch housing with the
three light kit mounting screws (FF) provided. Be sure to
tighten all screws.
QQ
9
B
FF
F
12
Installing the light bulbs
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
□
Install three 40 watt candelabra bulbs (LL) (included).
□
Remove the decorative nut (II), glass cap (HH) and the
metal nut (GG) from the light kit (F).
F
LL
GG
HH
II
Advertisement
Table of Contents
