Table of Contents
Advertisement
Configure the settings relating to the mail notification [Notification]
Click the [Notification] tab on the "Alarm setup" page. ( pages 20 and 21: How to display/operate the setup menu)
I E-mail notification setup
The settings relating to the alarm mail can be configured in this section. To provide notification of an alarm occur-
rence by e-mail, it is necessary to configure the settings of the mail server. ( page 65)
[To E-mail server setup]
When "To E-mail server setup" is clicked, the [Mail] tab
of the "Server setup" page will be displayed.
( page 65)
[E-mail notification]
Select "ON" or "OFF" to determine whether or not to
provide notification of an alarm occurrence by e-mail at
an alarm occurrence.
Default: OFF
[Attach image]
Select "ON" or "OFF" to determine whether or not to
attach an image to the mail to be sent.
Default: OFF
Note:
The settings for "Image capture size" of the "Alarm
image setup" section on the [Alarm] tab ( page 55)
will be applied to the size of the image to be
attached.
I E-mail notification setup
[Destination address]
Enter the destination mail address. Up to 4 destination
addresses can be registered.
To provide notification by e-mail when an alarm has
occurred, check the "Alarm" checkbox respective to the
desired address.
To provide notification by e-mail when any of the follow-
ing has occurred, check the "Diag." checkbox respective
to the desired address.
• When notification of the remaining space of the SD
memory card has been provided ( page 27)
• When the SD memory card has become full
• When mounting of the SD memory card failed
To delete the registered address, click the [DEL] button
respective to the desired address.
Number of characters for the destination mail
address: 3 - 128 characters
[Mail subject]
Enter the mail subject.
Number of characters for the mail subject: 0 - 50
characters
[Mail body]
Enter the mail body.
Number of characters for the mail body: 0 - 200 char-
acters
Note:
Notification mail will be sent with the following mes-
sage. (The message to be sent differs depending on
the status of the SD memory card.)
• "The SD memory card is full." (This message will
be sent when the SD memory card becomes
full.)
• "The SD memory card cannot be recognized."
(This message will be sent when the SD memory
card has failed to mount.)
61
Advertisement
Table of Contents
