Dcs Control - Graco GrindLazer 25P474 Operation - Repair - Parts

DCS Control

Buttons on the DCS Control have two functions, quick
press and long press. Quick press refers to pressing the
button and releasing the button quickly, while long press
is pressing the button and holding the button for two or
more seconds.
NOTE: "+" (plus) refers to above work surface. "-"
(minus) refers to below work surface.
Run Screen
DEPTH ..... + 0.21"
TARGET .... - - 0.08"
HOME ZERO CUT DEPTH
BUTTON BUTTON BUTTON
Home Button
Quick Press: Takes the drum to its highest position.
Long Press: Brings up Menu Screen.
3A7600C
Zero Button
Quick Press: Takes the drum to the work surface.
Current Drum
Position
Saved Cut Depth
Long Press: Reprograms the zero point to the current
UP BUTTON
drum position.
DOWN BUTTON
ti35660a
Setup
13